Avaya sip definition6/3/2023 ![]() ![]() The IP address entered here must match the IP address entered into System Manager. Enter the IP Address for the MS-1 VoIP Port.Check the checkbox for Use Dedicated VoIP Network Connection (LAN 3).In the General tab, check the checkbox for VoIP Enabled.In the Vocia software, open the MS-1 dialog.The MS-1 User Name would also be 7777777.Īfter completing the configuration within Avaya System Manager, several options in the MS-1 will need to be set to match the Session Manager settings. In the Figure 5 example the Insert Digits field is set to 7777777. Insert Digits: This field defines the digits that will be inserted into the re-written SIP header.In the Figure 5 example shown, all 7 digits are slated for re-write. The MS-1 supports a single user name so all digits must be replaced. Delete Digits: This defines the number of digits that will be removed from the original extension in the SIP Header.Min and Max settings could be expanded to extend the wildcard range to cover more extensions. The example rules indicate that the Min and Max are both 7, meaning that any extension would need to be exactly 7 digits wide to proceed. Min / Max: In the Figure 5 example case the extensions are always 7 digits in length.The matching number in this case is 600000(x) with x left undefined. The Figure 5 example has been setup to provide paging from (10) seven digit extensions 6000000-6000009. It is required for every phone extension that will support paging functionality, possibly wide enough to cover every phone in the system. Typically this will be setup to cover a large number of extensions. Matching pattern: Defines the portion of the original extension that will used to match the digit conversion.Here is a basic overview of the required Digit Conversion options listed in Figure 5 on the next topic. To facilitate this, the Avaya system can be configured to modify the SIP origination field of the SIP Header for any call placed through the trunk line. The MS-1 requires a single user name to be provided in the “from” address in the SIP header. Enter fromto=true in the Module Parameter field.If this is not an option to be selected by default, choose the selection then enter this Module name. The Module name MUST be specified as DigitConversionAdapter.Under Elements select the Routing menu.
0 Comments
Leave a Reply. |